Toyota LandCruiser 300 ROH RAID and Falken Wildpeak AT4W Upgrade in Adelaide
What wheel and tyre package was fitted to this Toyota LandCruiser 300? Autosport Tyre World Magill fitted this LC300 with ROH RAID 18x9 +35 wheels in 6x139.7, finished in Graphite Centre with Black Lip, and LT285/65R18 125S Falken Wildpeak A/T4W tyres. The package was fitted and balanced, then completed with a four-wheel alignment.
This is a real Adelaide workshop fitment, photographed outside our Magill store. It is a useful reference for LC300 owners researching all-terrain tyres, 18-inch wheels and alignment, but it is not a universal fitment approval. The vehicle variant, tyre placard, axle loads, wheel load rating, brake clearance, suspension, accessories and intended use must still be checked on the individual vehicle.
LC300 wheel and tyre package at a glance
| Item | Workshop fitment |
|---|---|
| Vehicle | Toyota LandCruiser 300 Series (LC300) |
| Wheel | ROH RAID |
| Wheel size | 18x9 |
| Offset | +35 |
| PCD | 6x139.7 |
| Finish | Graphite Centre with Black Lip |
| Tyre | Falken Wildpeak A/T4W |
| Tyre size | LT285/65R18 125S |
| Service | Fitting, balancing and four-wheel alignment |
| Workshop | Autosport Tyre World Magill, 647 Magill Road, Magill SA 5072 |
Why this 18-inch package suits the purpose of an LC300
The LandCruiser 300 is used in many different ways around South Australia: weekday commuting, family travel, towing, gravel-road touring and remote-area trips. A wheel and tyre upgrade therefore needs to be chosen as a complete system rather than by appearance alone.
An 18-inch wheel leaves more tyre sidewall than a larger-diameter wheel fitted with a comparable overall tyre diameter. For many touring owners, that extra sidewall is attractive because it can provide more scope for pressure management on unsealed roads and better impact compliance than a low-profile road setup. It does not make every 18-inch wheel suitable, however. Brake clearance, wheel shape, load rating and the exact LC300 variant still need to be confirmed.
The 18x9 ROH RAID gives the 285-section Falken tyre an appropriately purposeful footprint while the +35 offset keeps the package relatively considered for an LC300 application. Offset affects inner suspension clearance, outer guard position, scrub radius, steering feel and bearing loads, so it should never be selected in isolation.
ROH RAID 18x9 +35 6x139.7: what the specification means
The wheel description contains four important measurements:
- 18 is the wheel diameter in inches.
- 9 is the nominal wheel width in inches.
- +35 is the positive offset in millimetres, describing the mounting face position relative to the wheel centreline.
- 6x139.7 means six wheel studs on a 139.7 mm pitch circle diameter.
ROH lists the RAID as a 4WD alloy wheel available in several sizes, offsets and finishes. For the exact 18x9, 6x139.7, +35 specification, ROH lists Matte Black, Machined, Graphite Centre/Black Lip and Bronze Centre/Black Lip finishes. ROH also lists a 1050 kg wheel load rating and an approximate wheel weight of 13.5 kg for this specific size and offset.
Those figures are product specifications, not blanket approval for every modified LC300. If the vehicle has a GVM upgrade, heavy accessories, unusual axle loading or another modification, the wheel rating and complete fitment should be checked against the vehicle's certified requirements.
The Graphite Centre with Black Lip finish works especially well on this dark-grey LC300. It creates contrast around the spokes without looking overly bright, while the black outer lip visually connects the wheel to the Falken's sidewall and all-terrain tread.
Product links:
- Shop or enquire about ROH RAID wheels
- Browse the ROH Wheels collection
- ROH RAID manufacturer information
Why choose 285/65R18 Falken Wildpeak A/T4W tyres?
The fitted tyre is the LT285/65R18 125S Falken Wildpeak A/T4W. In tyre-size language, 285 is the nominal section width in millimetres, 65 is the sidewall aspect ratio, and 18 is the required wheel diameter in inches. The LT designation indicates light-truck construction, while the load and speed symbols must be checked against the vehicle and its use.
Falken positions the WILDPEAK A/T4W as an all-terrain tyre designed for mixed road and off-road use. Its manufacturer information highlights features intended to support durability, heat management, wet-weather traction and use across changing surfaces. Those are manufacturer claims; actual noise, comfort, grip and tyre life depend on the vehicle, load, pressure, alignment, rotation schedule, road surface and driving style.
For an Adelaide LC300 owner, the A/T4W can make sense when the vehicle needs to cover more than sealed suburban roads. A mixed-use 4WD may encounter hot summer bitumen, wet winter commutes, coarse country highways, gravel access roads and corrugated tracks in the same ownership cycle. An all-terrain tyre is selected to balance those demands, but there is always a trade-off: a more aggressive tread can feel and sound different from a road-focused highway-terrain tyre.
Before ordering, we confirm the required size, load rating and speed rating, and discuss how the vehicle is actually used. Towing, heavy accessories, long-distance touring and off-road pressure reduction all change what matters in a tyre recommendation.
Tyre links:
- Buy or enquire about LT285/65R18 125S Falken Wildpeak AT4W
- Browse Falken tyres
- Read our Falken Wildpeak AT4W review and buyer guide
Is 285/65R18 the standard LC300 tyre size?
Do not assume that 285/65R18 is the factory size for every LandCruiser 300. LC300 tyre and wheel specifications vary by grade, market and equipment. The correct starting point is the tyre placard and the vehicle's original specification, followed by checks for overall diameter, load capacity, speed rating, rim-width compatibility and physical clearance.
This workshop vehicle was assessed and fitted as a complete package. Another LC300 may have different suspension, accessories, wheel-arch clearance or legal requirements. Owners should also consider how a change in rolling diameter can affect speedometer accuracy, gearing, driver-assistance systems and spare-wheel compatibility.
For South Australian road use, modification compliance is the owner's responsibility. We recommend professional fitment inspection and, where necessary, advice from an appropriately qualified engineer or the relevant authority rather than relying on a photo or an online fitment claim.
The fitment checks that matter on an LC300
A professional wheel and tyre installation should address more than PCD and diameter. Important checks include:
1. Wheel load rating: suitable for the vehicle's axle loads and any certified GVM configuration.
2. Tyre load and speed rating: checked against the placard and applicable requirements.
3. Brake clearance: confirmed around the caliper, barrel and spoke profile.
4. Hub location and hardware: correct centre-bore solution, wheel nuts, nut-seat type and engagement.
5. Inner clearance: checked against suspension, steering and brake components.
6. Outer clearance: assessed at the guard and liner, including steering lock and suspension movement.
7. Overall diameter: considered for clearance, gearing, speedometer and electronic systems.
8. Spare compatibility: the spare should be considered as part of a touring package, not after the trip begins.
9. Balancing: each wheel and tyre assembly balanced to control speed-related vibration.
10. Alignment: measured after installation to establish a suitable steering and tyre-wear baseline.
Why four-wheel alignment completed the upgrade
Wheel balancing and wheel alignment are different services. Balancing corrects mass distribution in the rotating wheel-and-tyre assembly. Alignment measures the direction and angle at which the wheels sit relative to the vehicle and road.
After fitting this LC300's new ROH and Falken package, we performed a four-wheel alignment. This helps establish a measured baseline for steering-centre position, toe and the adjustable geometry available on the vehicle. It also gives the new tyres the best opportunity to wear evenly.
All-terrain tyres represent a significant investment, and alignment errors can damage that investment through feathering, inner-edge wear or outer-shoulder wear. Alignment should also be checked if the vehicle pulls, the steering wheel is off-centre, or the previous tyres show an irregular wear pattern. Suspension condition and tyre pressure still matter; alignment cannot compensate for worn components or incorrect inflation.
Learn more about wheel alignment in Adelaide.
Tyre pressure, rotation and maintenance after fitment
There is no single pressure that is correct for every LC300 load and driving condition. Start with the vehicle placard and professional advice, then adjust only with proper consideration of load, speed, tyre construction and surface. Highway towing, unloaded commuting and low-speed off-road driving place very different demands on a tyre.
For ongoing care:
- check pressures cold and before long trips;
- inspect the tread and sidewalls after off-road travel;
- rotate tyres on a schedule suited to the vehicle and wear pattern;
- recheck wheel-nut torque as advised after fitment;
- investigate vibration, pulling or steering changes promptly;
- arrange an alignment check if wear becomes uneven or after suspension changes and significant impacts.
LC300 workshop gallery
The photos below show the completed Toyota LandCruiser 300 on ROH RAID wheels and Falken Wildpeak A/T4W tyres at Autosport Tyre World Magill.




Frequently asked questions
What wheels were fitted to this Toyota LandCruiser 300?
ROH RAID alloy wheels in 18x9 +35, 6x139.7, finished in Graphite Centre with Black Lip.
What tyres were fitted to the LC300?
The vehicle received LT285/65R18 125S Falken Wildpeak A/T4W all-terrain tyres.
Does ROH list a load rating for this RAID specification?
Yes. ROH lists 1050 kg per wheel for the RAID 18x9, 6x139.7, +35 specification. Vehicle and axle requirements still need to be checked, especially where a GVM upgrade or heavy accessories are involved.
Will 285/65R18 fit every LC300 without modification?
No universal claim should be made. Grade, suspension, wheel offset, accessories, tyre construction and legal requirements can change the result. A physical fitment check and placard review are required.
Why use an 18-inch wheel on a touring 4WD?
An 18-inch wheel can provide useful tyre sidewall for mixed-road touring compared with a larger wheel and lower-profile tyre of similar overall diameter. Brake clearance, load rating and exact fitment must still be confirmed.
Is the Falken Wildpeak AT4W suitable for daily driving?
It is designed as an all-terrain tyre for mixed use and can be considered for daily driving when its size, rating and performance trade-offs suit the vehicle and driver. Expect an all-terrain tyre to differ from a road-focused tyre in feel, noise and efficiency.
Should an LC300 have a wheel alignment after new wheels and tyres?
A measured alignment is a sensible finishing step, particularly when fitting a new wheel-and-tyre package or when the old tyres show irregular wear. It helps set steering centre and reduce avoidable tyre scrub.
Where can I buy ROH RAID wheels and Falken AT4W tyres in Adelaide?
Autosport Tyre World Magill supplies and fits ROH wheels and Falken tyres, with balancing, fitment checks and wheel alignment available at 647 Magill Road, Magill SA 5072. Call 0452 641 023 to confirm current stock, pricing and suitability for your LC300.
Book an LC300 wheel and tyre fitment check in Adelaide
This LC300 shows what a well-matched 18-inch 4WD package can achieve: a purposeful stance, an all-terrain tyre suited to mixed use, and a measured alignment to finish the job properly.
If you are comparing LC300 wheels in Adelaide, 285/65R18 all-terrain tyres, ROH RAID wheels, Falken Wildpeak AT4W tyres or four-wheel alignment in Magill, speak with the team before ordering. We can check the vehicle, intended use and complete specification rather than relying on size alone.
Autosport Tyre World Magill
647 Magill Road, Magill SA 5072
Phone: 0452 641 023
Product availability, pricing and lead times can change. Contact the store to confirm current details. Fitment and compliance depend on the individual vehicle and its modifications.